A force of 200 N is applied at one end of a wire of length 2 m and having area of cross-section 10-2 cm2. The other end of the wire is rigidly fixed. It coefficient of linear expansion of the wire α = 8 x 10-6/oC and Young's modulus Y = 2.2 x 1011 N/m2 and its temperature is increased by 5oC, then the increase in the tension of the wire will be :
2.4 N
8.8 N
4.2 N
4.4 N
Young's modulus of the material of a wire of length L and radius r is Y N/m2. If the length is reduced to L/2 and radius to r/2, the Young's modulus will be :
Y/4
Y/2
Y
2Y
A wire of density 9 gm/cm3 is stretched and clamped between two clamps distant 100 cm apart by a force which produces an elongation of 0.05 cm in it. If Y = 9 x 1011 dyne/cm2 then the minimum frequency of transverse vibrations will be :
15.15 per sec
25.25 per sec
35.35 per sec
53.53 per sec
One end of a uniform wire of length L and weight W is attached rigidly to a point in roof and a weight W1 is suspended from its lower end. If S is the area of corss-section of the wire, the stress in the wire at a height of 3L/4 from its lower end is :
For the same cross-sectional area and for a given load, teh ratio of depressions for the beam of a square cross-section and circular cross-section is :
3 : π
π : 3
1 : 1
1 : π
Two rods of different materials having coefficients of linear expansion α1 and α2 , Young's modulii Y1 and Y2 respectively are fixed between two rigid massive walls. The rods are heated such that they undergo the same increase in temperature. There is no bending of rods. If α1 : α2 =2 : 3, the thermal stresses developed in the two rods are equal provided Y1 : Y2 is equal to :
2 : 3
3 : 2
4 : 9
The Poisson's ratio for a material is 0.1. If the longitudinal strain of a rod of this material is 1 x 10-3, then the percentage change in the volume of rod will be :
8%
0.8%
0.08%
0.008%
A uniform elastic plank moves due to a constant force F placed over a smooth surface. The area of end face is S and Young's modulus of the material is E. What is the average strain produced in the direction of the force?
F/4SE
Zero
F/SE
F/2SE
The Young's modulus of a wire is Y. If the energy per unit volume is E, then the strain will be :
EY
E/Y
The upper end of a wire, 1 m long and 4 mm radius, is clamped. The lower end is twisted by an angle of 30o. The angle of shear at the surface is :
12o
1.2o
0.12o
0.012o